Frequently Asked Questions...
can u please rate my dragon deck.or give improvements?
this is my dragon deck
monsters
Victory Dragon
blue eyes white dragon*3
Lord of D.
Palindin of white dragon*2
masked dragon*2
armed dragon level3*2
sprit ryu
gray wing
red eyes b.chick
baby dragon
horus the black flame dragon lv4 lv6
mirage dragon
winged dragon guaridian of the fortess#1
curse of dragon
kaiser sea horse
fusion deck
blue eyes ultimate dragon*3
dragon master knight*3
black luster soldier*3 ritual
spell
white dragon ritual*2
stamping destruction*2
dragons mirror
the flute of summiong dragon
mystical space typhoon
polymeriozaon*3
mega ton magical cannon
nobleman of crossout
fusion weapon
trap
dragons rage
the dragons bead*2
disappear
return from the differnt dimension
thanks and please rate ^^
Answer:
get rid of black luster solder
and just get some more of your lower leval dragons
but get rid of baby dragon
put in one more the flute of summiong dragon
plus for an aousome combo
unfusion and huracane attack
i think its huracane attack
if you have three of one monster of the same name in play then thay may all attack directly
that card ability
i would like to duel you: http://dclegend.proboards74.com/index.cgi
i recomend it
![]() MEGA IDEA BOOK #1 for Perler's beads 400 ideas!! US $3.95
|
![]() Totally Me! Wooden Bead Mega Creations Set US $29.99
|
![]() BIZU Style Studio Mega Pack * Store, Select, Style * 100+ Twist on Beads -NIB US $28.99
|
Bead Mega
Mega Man 2 Title Screen in Beads
How to Repair Caning
How to Repair Caning
In antique furniture, caning is usually handwoven. It is threaded through individual holes in the frame and woven in strand by strand. This type of caning should be replaced by a professional. In most newer furniture, the cane is prewoven. An entire sheet of cane is attached in a groove around the open frame. Sheet cane is easy to replace.
Start by removing the old cane. If you can, pull the cane out of the groove, using a chisel to pry up the spline that holds it. If the spline is stubborn, you may have to soak the area with a towel soaked in very hot water and wrung almost dry. When the adhesive has softened, place a block of wood under the caning and tap the block with a hammer. This should dislodge the caning and the spline from the seat frame. After removing the cane, clean out the groove with a chisel. Make sure it's completely clean and dry before you install the new cane.
To replace the cane, buy a new spline and new prewoven sheet caning, about 1 to 11/2 inches larger all around than the opening. Make sure the spline is the right width for the groove. Soak the cane and the spline in warm water for about 10 to 15 minutes to soften the fiber.
When the spline and the cane are pliable, blot them dry with a towel. Lay the caning over the groove, shiny side up. Starting at the center of one short side, pound the edge of the caning into the groove with a narrow wood wedge -- cut the wedge from a 1 X 2 or a 1 X 3, and use a hammer to tap it along the caning.
The bottom of the taper on the wedge should be slightly smaller than the groove. Work along the side of the frame toward the corners, wedging the cane firmly and squarely down into the groove. If the cane isn't securely wedged, it will come loose.
When the first side of the cane is in place, clamp the caned edge between two pieces of 1 X 2 or 1 X 3 to prevent the caning from popping out of the groove. Then stretch the sheet of cane across the frame and wedge the opposite side, starting at the center and working out.
Repeat the procedure, clamping each side as you go, to secure the remaining sides. As you work, the caning may start to dry out. If necessary, rewet it to keep it pliable.
When the caning has been tapped into the groove all around the frame, trim off any excess at the outside corner of the groove. Set a sharp chisel into the groove to cut the cane. Then lay a narrow bead of white glue all around the groove on top of the caning.
Blot the spline dry, and force it into the groove over the caning, using a wooden or rubber mallet to drive it into the groove. Pull the spline tight as you go, and ease it around the corners. You may have to install the spline in several pieces; if so, make sure the ends butt together tightly to form a continuous spline. Finally, wipe off any excess glue.
About the Author
Mega Furniture™ is designed for endless elegance. Each teak & rattan furniture piece is crafted for style, comfortable and durability from the world’s finest teak & rattan. Our factory direct pricing and manufacturing expertise are our competitive advantages.
All the advances in modern and hand made manufacturing materials cannot replace the timelessness of solid teak wood furniture. The sturdiness and simple design of a mission style teak wood Batavia Chair a sense of tradition and permanence to any home. Add the Batavia Chair to any room and you’ll enjoy a feeling of history as rich as the Indonesia country itself.
The furniture is not only strong and long-lasting, but its sober shapes and pretension-free craftsmanship make items of Javanese teak furniture into timeless masterpieces.
Labels: bar-stools, folding chairs, chairs, benches, deep seating, folding table,
Tables, bar, loungers, accessories.
Please visit our online furniture at : http://www.megafurniture.net
Here are a list of other products on Arts And Crafts Ideas, come check these out:



















